Teqball SMART indoor, Assembly Instructions Manual

TQ21D1-3.12

GENERAL

Thank you for choosing the Teqball Smart table. We would like to give you some advice 
for the assembly. Please read and follow these instructions carefully.

SAFETY NOTICE

ASSEMBLY

The Teqball Smart table must be assembled by at least two adults following the numerical 
order of the assembly instructions. Before assembling, please check that all the proper 
parts are contained in the packages. The indicated quantities of parts make it possible to 
go through the assembly stages. Use the tools recommended on page 5.
IMPORTANT: Assembly should be carried out on clean, dry, level surface. Please ensure 
there is nothing on the floor that could scratch the tabletop. During the assembly put the 
packages to the ground and hold the parts above them to prevent the damage that is 
caused by falling or impact. During assembly remove the protection foil from the PMMA 
net and from the surface of the HPL.

Any person handling or using the Teqball Smart table must follow the instructions as 
described in this document. The person in charge of assembling and using the Teqball 
Smart table must ensure that the recommendations for use given in this document and 
in the Owner's Manual of the Teqball Smart table are seen by all users. In communal 
use, it is strongly recommended that the instructions and diagrams are displayed.
Only use the Teqball Smart table after it has been fully assembled and after checking 
that the fasteners are tightened properly and the wheels, gas springs and the safety 
locks, work properly. Later, depending on frequency of use (but at least twice a month) 
check all fasteners, wheels, gas springs and the safety locks regularly to ensure that 
their condition is good. The fasteners are coated with adhesive which is inactive until 
the coated fasteners are used. During assembly the adhesive is activated. The adhesive 
can prevent the self-loosening of fasteners, but the effect of the adhesive decreases 
with every assembly. Please do not remove the adhesive from the fasteners.
Assembly must be carried out at least by two adults during all stages.

2/24