OPERATING MANUAL
OPERATING MANUAL
English
GB
English
GB
GB
GB
Close the machine and connect the main
cable to positive or negative polarity
Connect the workpiece cable
Press the gun switch; the wire
drives out slowly for 5 seconds,
than stops and the frontal panel
shows inc 10: that means the state
of inch wire is active
Release the switch and push it
again.
The wire will drive out continuosly
at a speed of approx 10 meters/min
until the switch remain pressed
Summary of Contents for 206
