www.TERAFLEX.com
16
Revision B
999376
801.713.3314 • TERAFLEX.com
999368
Rev C
JT Tire Clearance Guide
for vehicles with FACTORY FENDER FLARES
33” TIRES
33” TIRES
35” TIRES
37” TIRES
39” TIRES
35” TIRES
37” TIRES
JT Rubicon
with Factory Fender Flares
:
with Factory Fender Flares
:
*For vehicles with TERAFLEX Nomad Wheels, add 0.5” Bump Stop to the rear axle.
*For vehicles with TERAFLEX Nomad Wheels, add 0.5” Bump Stop to the rear axle.
• When installed with a 1.5” Leveling Kit
- 1” Front & No Rear Bump Stop*
• When installed with a 1.5” Leveling Kit
- 1” Front & No Rear Bump Stop*
• No Front or Rear Bump Stop
JT Sport/Overland
• When installed with a 2.5”+ Lift Kit
- 2″ Front & 1″ Rear Bump Stops
• When installed with a 2.5”+ Lift Kit
- 2″ Front & 1″ Rear Bump Stops
• 2″ Front & 2.5″ Rear Bump Stops
• 4″ Front & 4″ Rear Bump Stops
• 4″ Front & 3.5″ Rear Bump Stops
(2” Upper/1.5” Lower)
• 3″ Front & 2.5″ Rear Bump Stops
2"
2"
1"
1"
2"
4"
3"
4"
0.5"
1.5"
0.5"
1.5"
2"
2.5"
2"
2"
**Additonal Bump Stops Required
**Additonal Bump Stops Required
Notes:
- Additional Front and Rear Bump Stop Strike Pads are available
for individual purchase.
- If installing on a Eco-Diesel Jeep, the jounce tubes are 1.375”
longer, so you should subtract 1.375” from the front bump stop
stack.
- A minimum of 2” bump stop is needed if 3.5”-4.5” Lift Falcon
Shocks are installed.
TeraFlex Bump Stop Strike Pad Extensions allow the use of larger
tires and factory fender flares by limiting suspension up travel.
JT Rubicon models feature high-clearance fenders that allow for
more up travel, while the lower-clearance fenders on JT Sport
and Overland restricts tire size due to fender rubbing.
In order to address these fender differences, TeraFlex designed a
proprietary modular bump stop system, which can be adapted to
fit several different tire size configurations.
Additional 0.5″ shims can be added to fine tune bump stop height
and further limit suspension up travel.
IMPORTANT: Recommended Bump Stop configuration is based
on tested tires. Not all tires measure the same. Before driving,
cycle the suspension to check for rubbing or contact of the
shocks, springs, or suspension componets.
Compatable Lift Kit Heights: 1.5”
Compatable Lift Kit Heights: 1.5”-2.5”
Compatable Lift Kit Heights: 1.5”-4.5”
Compatable Lift Kit Heights: 2.5”-4.5”
Compatable Lift Kit Heights: 3.5”-4.5”
Compatable Lift Kit Heights: 4.5”
Compatable Lift Kit Heights: 4.5”
