5 - 24
DPL-25S • DPL-30S • DPL-35S Super Series
Part No. 40462
September 2016
Section 5 - Troubleshooting Flow Charts
Chart 11
Auxiliary
Platform
Lowering
Will Not
Operate
Check the low auxillary
battery indicator (red
LED) light. If on, it is
showing a low voltage
condition.
off
on
Disconnect the main
power source. Check for
power at terminal 9 and
9A of the 13 pole terminal
strip (J1) located in the
ground control box.
Replace the 8 -1.5V, AA
size batteries.
0V DC
Replace the P.C. board
OR contact Genie
Industries Service
Department.
If power is seen then the
symptom would be that
the auxillary lowering
from the platform would
work and not from the
ground control box.
wont
lower
from
base
Replace the auxillary
down N.O. contact block
located in the ground
control box OR repair the
red wire from terminal 9a
of 13 pole terminal strip
(J1).
Check for power at
terminal 1 of the 3 pole
terminal strip (J2) in the
ground control box.Put
the positive lead of
voltage meter on terminal
1 and the negative lead
on terminal 2 the
grounding terminal.
0V DC
12V DC
Check the auxillary
lowering battery holder
wires (red wire connects
to terminal 1 and black
wire connects to terminal
2) for loose connections
at the J2 terminal strip
OR check for defects in
the battery holder and its
wires.
Check the auxillary
lowering battery holder to
make sure that the
batteries have been
installed.
yes
Install the 8 - 1.5V, AA
size batteries.
no
bad
Correct the loose
connections at the J2
terminal strip OR
Replace the battery
holder.
12V DC
