Part No. 404632
DPL-25S • DPL-30S • DPL-35S Super Series
6 - 1
September 2016
Section 6 • Schematics
Schematics
Observe and Obey:
Troubleshooting and repair procedures shall be
completed by a person trained and qualified on
the repair of this machine.
Immediately tag and remove from service a
damaged or malfunctioning machine.
Repair any machine damage or malfunction
before operating the machine.
Before Troubleshooting:
Read, understand and obey the safety rules
and operating instructions printed in the
Genie AWP Super Series Operator's Manual
and the Genie IWP Super Series Operator's
Manual
.
Be sure that all necessary tools and test
equipment are available and ready for use.
About This Section
There are two groups of schematics in this section.
Electrical Schematics
Electrocution/burn hazard. Contact
with electrically charged circuits
may result in death or serious
injury. Remove all rings, watches
and other jewelry.
Hydraulic Schematics
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
General Repair Process
Malfunction
discovered
Identify
symptoms
Troubleshoot
Perform
repair
Return to
service
problem
solved
problem
still exists
Inspect
and test
