Part No. 40462
DPL-25S • DPL-30S • DPL-35S Super Series
7 - 1
September 2016
Section 7 - Repair Procedures
Repair Procedures
About This Section
Most of the procedures in this section should only
be performed by a trained service professional
in a suitably equipped workshop. Select the
appropriate repair procedure after troubleshooting
the problem.
Perform disassembly procedures to the point
where repairs can be completed. Then to
re-assemble, perform the disassembly steps in
reverse order.
General Repair Process
Observe and Obey:
Repair procedures shall be completed by a
person trained and qualified on the repair of this
machine.
Immediately tag and remove from service a
damaged or malfunctioning machine.
Repair any machine damage or malfunction
before operating the machine.
Before Repairs Start:
Read, understand and obey the safety rules
and operating instructions in the
Genie DPL
Super Series Operator's Manual.
Be sure that all necessary tools and parts are
available and ready for use.
Read each procedure completely and adhere to
the instructions. Attempting shortcuts may
produce hazardous conditions.
Malfunction
discovered
Identify
symptoms
Troubleshoot
Perform
repair
Return to
service
problem
solved
problem
still exists
Inspect
and test
Symbols Legend
Indicates the presence of a hazard
that
will
cause death or serious
injury.
Indicates the presence of a hazard
that
may
cause death or serious
injury.
Indicates the presence of a hazard
that
will
or
may
cause serious
injury or damage to the machine.
Indicates special operation or
maintenance information.
Indicates that a specific result is expected after
performing a series of steps.
