7 - 2
DPL-25S • DPL-30S • DPL-35S Super Series
Part No. 40462
September 2016
Section 7 - Repair Procedures
1-2
Base Components
How to Adjust the Platform
Manual Lowering Cable
1 Remove the base-end covers to access the
platform manual lowering cable.
2 Check to be sure:
Steer handle end:
• Actuator bracket is connected to the base
and the manual lowering valve
• Manual lowering cable is connected to the
base with two lock nuts
• Manual lowering cable is attached to the
actuator bracket
Ladder end:
• Actuator bracket is connected to the base
and the manual lowering valve
• Manual lowering threaded rod is attached
to the actuator bracket
3 Adjust the manual lowering lever. Adjust the
cable and the threaded rod at the lever. Be sure
to maintain equal tension on the cable and
threaded rod.
Do not over-tighten the platform
manual lowering cable. The
platform may not raise if there is to
much tension on the cable.
Base Assembly
1-1
Interlocks
The interlock contact brackets indicate proper
installation of the outriggers and only allow the
machine to operate when the outriggers are
properly installed and adjusted.
How to Remove an Interlock
Contact Bracket
1 Fully lower the platform, turn the machine off
and remove the key.
2 Store the outriggers in the storage sockets.
3 Trace the interlock contact bracket wires into
the junction box.
4 Label and disconnect the contact bracket wires.
5 Remove the interlock contact bracket mounting
fasteners from the outrigger base socket.
6 Grasp the interlock contact bracket inside the
base outrigger socket and pull it out with the
wires.
