4.
Flip the assembly over and lay it on a table, then
remove the pivot caps from both sides as shown.
(fig. 16-58)
Note:
Behind each cap is a pivot that aligns with the
two small pivot wires attached to the swash plate.
Remove these from their cavities while installing the
swash plate.
5.
Assemble the bearing halves to the bottom of the
swash plate, orient the pins so that they are verti-
cal and then lower the assembly into place over
the shaft. (fig. 16-59)
6.
Once installed, make sure each pin is centered in
its opening, then slide the pivot into the hole so
that it mates with the pin. (fig. 16-60)
7.
Once the pivots are installed, check to make sure
both of them are properly mated with the pins.
Using a blade type screwdriver, turn the pivots
slightly to the right or left. The swash plate should
move with the pivot as each one is turned. If it
does not move, repeat step 6, then recheck. Once
correct, reinstall the caps to secure them in place
(fig. 16-61)
8.
Reassemble the piston and barrel portion of the
pump as found upon disassembly, then slide it
back into the housing. (fig. 16-62, 16-63)
Note:
Make sure the long end of the swash plate
alignment bar is pointing inward to ensure proper oper-
ation. (fig. 16-62)
9.
Reinstall and tighten the cover bolts to secure the
cover. (fig. 16-63)
16-13
Rubber Track Loader
16. Hydraulic Component Service
16-58
16-59
Pin
16-60
Pin
16-61
16-62
Long end
16-63
https://tractormanualz.com/
Summary of Contents for ASV SR70
