Hydraulic Fluid/Filter Change
Hydrostatic components require extremely clean oil in
order to have a long service life. Use extreme caution
when changing the hydraulic oil. Introducing dirt or
debris could be detrimental to the hydraulic system.
ASV recommends service intervals of 500 hours for
hydraulic fluid and 250 hours for hydraulic fluid filters.
To change the hydraulic fluid:
1.
Locate the hydraulic system drain access situated
in the belly pan between the axles on the right side
of the machine. (fig. 4-54)
2.
Remove the drain plug using the correct size allen
type wrench or allen socket to avoid damaging the
drain plug. (fig. 4-54, 4-55)
3.
Drain the hydraulic fluid into a suitable catch con
tainer.
4.
Locate the two hydraulic filters underneath the cab
on the left side of the machine. (fig. 4-56)
5.
Thoroughly clean around the filters to prevent dirt
or debris from entering the system and remove the
filters by hand or with a strap as required.
6.
Check to make sure the filter gaskets are still pres
ent on the old filters. If not, check the filter heads
to make sure they are free from old gasket materi
al prior to installing the new filters.
7.
Prepare the new filters by rubbing a small amount
of fresh hydraulic oil onto the filter gasket surface
and then threading them onto their respective filter
heads. Tighten filters by hand as instructed by the
label located on the filter or filter box.
8.
Install the hydraulic system drain plug and tighten.
9.
Remove the hydraulic reservoir filler cap (black)
and fill the hydraulic system with ASV Posi-Lube
Premium All Season MV Hydraulic Oil or equiva
lent until the full mark on the hydraulic fluid sight
gauge has been reached (approx. 12.5 gal.).
(fig. 4-57,4-58)
Note:
When checking or adding to the hydraulic fluid
level, do so with the lift arms in the lowered position. If
the level is checked with the lift arms in the raised
position, an inaccurate reading will result.
Note:
When adding hydraulic fluid, add fluid slowly
until it is visible in the sight gauge. Once visible, add
fluid in one quart increments until the full mark has
been reached.
10.
Install and secure the hydraulic reservoir filler cap.
11.
Start the machine and operate all hydraulic circuits
to work any trapped air out of the system.
•
Drive the machine forward and backward.
•
Raise and lower the lift arms(unloaded).
•
Dump and curl bucket/quick attach.
12.
Once you have purged the air from the system,
check the level on the hydraulic fluid level sight
gauge. If the level is low repeat step 9 and 10 to
complete the procedure.
4-16
Rubber Track Loader
4. Maintenance
4-54
4-56
4-57
4-58
4-55
Full
Low
https://tractormanualz.com/
Summary of Contents for ASV SR70
