Service and Repair Manual
March 2021
Scissor Components
86
GS
™
-30 • 32 • 46 • 47
Part No. 1272217GT
28 Remove the external snap rings and retaining
fasteners from the number 4 center pivot pins
(index #2).
29 Use a soft metal drift to remove the number
4 center pivot pins (index #2).
30 Remove the retaining fasteners from the
number 4 pivot pin (index #14) at the non-
steer end of the machine.
31 Use a soft metal drift to remove the number
4 pivot pin (index #14) from the non-steer end
of the machine. Remove the number 4 outer
arm (index #13) from the machine.
Crushing hazard. The number
4 outer arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
32 Remove the number 4 cable bridge mounting
fasteners and remove the cable bridge from
the machine.
33 Attach a lifting strap from an overhead crane
to the number 4 inner arm (index #12).
34 Remove the retaining fasteners from the
number 4 pivot pin (index #3).
35 Use a soft metal drift to remove the number
4 pivot pin (index #3) at the steer end.
Remove the number 4 inner arm (index #12)
from the machine.
Crushing hazard. The number
4 inner arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
36 Remove the cables from the number 3 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
37 Remove the number 3 cable bridge mounting
fasteners and remove the cable bridge from
the machine.
38 Attach a lifting strap from an overhead crane
to the number 3 outer arm (index #4) at the
ground controls side.
39 Remove the external snap rings and retaining
fasteners from the number 3 center pivot pins
(index #4).
40 Use a soft metal drift to remove the number
3 center pivot pin (index #4) at the ground
control side.
41 Remove the retaining fasteners from the
number 3 pivot pin (index #17) at the non-
steer end of the machine.
