Service and Repair Manual
March 2021
Scissor Components
80
GS
™
-30 • 32 • 46 • 47
Part No. 1272217GT
34 Remove the pin retaining fasteners from the
lift cylinder rod-end pivot pin (index #3). Use a
soft metal drift to remove the pin.
Bodily injury hazard. The
cylinder may fall when the rod-
end pivot pin is removed if not
properly supported.
35 Lower the cylinder onto the number 1 inner
arm (index #8).
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
36 Attach a lifting strap from an overhead crane
to the number 3 inner arm (index #10).
37 Remove the retaining fasteners from the
number 3 pivot pin (index #4) at the steer end.
38 Use a soft metal drift to remove the number
3 pivot pin (index #4). Remove the number
3 inner arm (index #10) from the machine.
Bodily injury hazard. The
number 3 inner arm may
become unbalanced and fall if
not properly supported when
removed from the machine.
39 Remove the cables from the number 2 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
40 Remove the external snap rings and retaining
fasteners from the number 2 center pivot pin
(index #5) at the ground controls side.
41 Remove the number 2 cable bridge mounting
fasteners and remove the cable bridge from
the machine.
42 Attach a lifting strap from an overhead crane
to the number 2 outer arm (index #14) at the
ground controls side.
43 Use a soft metal drift to remove the number
2 center pivot pin (index #5) at the ground
controls side.
44 Remove the retaining fasteners from the
number 2 pivot pin (index #15) at the non-
steer end of the machine.
45 Use a soft metal drift to tap the number
2 pivot pin (index #15) halfway out at the non-
steer end of the machine. Remove the
number 2 outer arm (index #14) from the
ground controls side of the machine.
Bodily injury hazard. The
number 2 outer arm at the
ground controls side may
become unbalanced and fall if
not properly supported when
removed from the machine.
46 Attach a lifting strap from an overhead crane
to the number 2 outer arm (index #14) at the
battery pack side.
47 Remove the external snap rings and retaining
fasteners from the number 2 center pivot pin
(index #5) at the battery pack side.
48 Use a soft metal drift to remove the number
2 center pivot pin (index #5) at the battery
pack side.
Bodily injury hazard. The
number 2 outer arm at the
battery pack side may become
unbalanced and fall if not
properly supported when
removed from the machine.
