Service and Repair Manual
March 2021
Ground Controls
22
GS
™
-30 • 32 • 46 • 47
Part No. 1272217GT
The ground controls, used to operate the machine
from the ground, can also be used to tune the
performance of the machine.
The ground controls consist of an Electronic
Control Module (ECM), emergency stop button,
key switch and circuit breaker.
Activating the function enable button and the up or
down at the same time, sends a signal to the
(ECM). This allows the platform to be raised or
lowered at the ground controls.
Note: Steer and drive functions are not available at
the ground controls.
When the ECM is in the set up mode, the ground
controls are used to adjust the function speed
parameters, machine models, or machine options.
For further information or assistance, contact
Genie Product Support.
1 machine setup escape button
2 machine setup scroll up button
3 LCD readout
4 machine setup scroll down button
5 machine setup enter button
6 Key switch KS1
7 red Emergency Stop P1
8 circuit breaker CB2
9 Diagnostic port (if equipped)
10 platform down button
11 lift function enable button
12 platform up button
