Third Edition • First Printing
Operator's Manual
Inspections
Part No. 1305657GT
GS
™
-
2669RT • GS
™
-
3369RT • GS
™
-4069RT
31
Test Drive and Braking
29
Press and hold the function enable switch on
the control handle.
30
Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
31
Press and hold the function enable switch on
the control handle.
32
Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
Test Limited Drive Speed
33
Press and hold the lift function enable button.
Raise the platform approximately 7.5 ft / 2.28 m
from the ground.
34
Press and hold the function enable switch on
the control handle.
35
Slowly move the control handle to full drive
position.
Result: The maximum achievable drive speed
with the platform raised should not exceed
0.44 ft / 13 cm per second.
If the drive speed with the platform raised exceeds
0.44 ft / 13 cm per second, immediately tag and
remove the machine from service.
Summary of Contents for Genie GS-2669RT
Page 56: ......
