Third Edition • First Printing
Operator's Manual
Inspections
Part No. 1305656GT
GS
™
-
2669BE • GS
™
-
3369BE • GS
™
-4069BE
31
Test Stowed Drive Speed
56
Press and hold the lift function button, and
press the platform down button.
Result: The platform should lower.
57
Press and hold the function enable switch on
the control handle. Slowly move the control
handle to full drive position in the direction
indicated by the blue arrow.
Result: The maximum achievable drive speed
with the platform stowed should not exceed
6.6 ft / 2 m per second.
If the drive speed with the platform stowed exceeds
6.6 ft / 2 m per second, immediately tag and
remove the machine from service.
58
Press and hold the drive/steer function enable
switch on the control handle. Slowly move the
control handle to full drive position in the
direction indicated by the yellow arrow.
Result: The maximum achievable drive speed
with the platform stowed should not exceed
4.4 ft / 1.34 m per second.
If the drive speed in reverse with the platform
stowed exceeds 4.4 ft / 1.34 m per second,
immediately tag and remove the machine from
service.
Test the Outrigger System (if equipped)
59
Press the outrigger function button.
On the LCD screen, a circle below
the outrigger function symbol will
turn on.
If the control handle is not moved within seven
seconds of pushing the outrigger function button,
the circle below the outrigger function symbol will
turn off and outrigger function will not operate.
Press the outrigger function button again.
60
Press and hold the function enable switch on
the control handle.
61
Move the control handle in the direction
indicated by the yellow arrow.
Result: The outriggers should extend. The
individual outrigger indicator lights will flash
green as the corresponding outrigger extends.
62
Continue holding the control handle in the
direction indicated by the yellow arrow until all
outrigger indicator lights turn solid green and a
long beep is heard from the platform controls
alarm. The machine is now level. At this point,
the drive and steer functions are disabled.
Note: If the control handle is released too soon
during extension, the outrigger indicator lights will
continue to flash green, indicating the outriggers
are not contacting the ground.
Note: If the control handle is released too soon after
the outriggers have contacted the ground, a long
beep will not be heard at the platform controls and
the outrigger indicator lights will be solid green. If a
long beep is not heard and the outrigger indicator
lights are solid green, this condition may indicate
the outriggers are not fully deployed or the machine
is not level.
Summary of Contents for Genie GS-3369BE
Page 58: ......