Third Edition • First Printing
Operator's Manual
Operating Instructions
Part No. 1305656GT
GS
™
-
2669BE • GS
™
-
3369BE • GS
™
-4069BE
43
To reset thermal limit cutout
If the platform controls LED readout displays fault
codes F053, F054, F055 or F056, the machine has
overheated. The fault condition must be repaired or
removed before resuming machine operation.
1
Push in the red Emergency Stop button to the
off position.
2
Allow the machine to cool for approximately
5 minutes before resuming machine operation.
3
Pull out the red Emergency Stop button to the
on position.
Operation from Ground with
Controller
Maintain safe distances between the operator,
machine and fixed objects.
Be aware of the direction the machine will travel
when using the controller.
Battery Level Indicator
Use the LED diagnostic readout to determine the
battery level.
Note: When a blinking LO code appears on the
platform controls LED display, the engine must be
started or the machine must be taken out of service
and charged. Otherwise, all machine functions will
be disabled.
Full Charge
Half Charge
Low Charge
LO Flashing
Engine Restart
Summary of Contents for Genie GS-3369BE
Page 58: ......