Maintenance
Checking the machine START CONTROL
(20)
(at every use)
Attempt to start the engine with the forward or reverse
gear put.
The engine must not start. If the engine starts,
contact the GENIE Technical Service.
Repeat the operation putting fi rst one gear, then
the other.
Checking the operation of the EMERGENCY
PUMP (19)
(weekly)
If the machine is equipped with an emergency pump,
check it is in effi cient working order every week.
This pump is not used regularly and, as a result, it
could get damaged and be out of order in case of
need.
To check that the pump is in effi cient order, stop the
engine, press the on-off button for some seconds
and check that the pump works regularly.
EMERGENCY STOP PUSHBUTTON
(22)
Set
on the dashboard, to the right of the steering
wheel.Pressing down this button stops the engine
of the machine.
Before starting work again, find and rectify the
relevant causes, then reset the button to neutral
position turning it clockwise.
Checking the emergency stop pushbutton
(at
every use)
To check the efficiency of this pushbutton, simply
press it down during a movement. The pressure of
the pushbutton shall cause the movement to stop
and the engine to shut down.
C
105
60
VOLT
15
11
MODE
1
2
19
20
22
102 GTH-4518ER - GTH-4020ER - GTH-6025ER Part No. 57.0009.0404
Operator’s Manual
First Edition - Third Printing
Summary of Contents for Genie GTH-4020 ER
Page 188: ......
