ADJUSTING THE SEAT
Position the seat so you can comfotarbly reach all
the controls. The handler seat is fitted with devices
which let you adjust the seat springing, height and
distance from the controls, the backrest angle and
the armrest height.
•
Adjusting the seat distance from the
controls
To slide the seat forward or back, rotate lever
A
and push the seat to the desired direction. Then
release the bar and make sure that the seat locks
in position
.
•
Adjusting seat height and springing
Free the lever of knob
B
and turn clockwise or
counter-clockwise until reaching the desired
springing. Once you’are correctly seated in the
seat check that the yellow indicator
C
is in the
green field.
•
Adjusting the backrest angle
Operate
lever
D
, press your back firmly against
the backrest and put the backrest at the angle
you wish, then release the lever.
•
Adjusting the armrest height
Raise
armrest
E
and turn wheel
F
to put the
armrest at the height you want.
CAUTION
• The seat is for one person only.
• Don’t adjust the seat when the machine is
moving.
FASTENING THE SEAT BELTS
Sit correctly in the driving seat; then:
• The safety belts are equipped with reel retractor.
To fasten the belt, pull tab
1
and push it into buckle
2
.
• To release the belt, push button
3
and remove
the tab from the buckle.
• Make sure that the buckle is correctly located at
the hip point and not on the stomach.
• Operate the end adjusters to reach the length you
wish and make sure the buckle is always in the
middle.
3
2
1
Operating Instructions
Part No. 57.0009.0404 GTH-4518ER - GTH-4020ER - GTH-6025ER 63
Operator’s Manual
First Edition - Third Printing
Summary of Contents for Genie GTH-4020 ER
Page 188: ......
