May 2015
58 GTH 4016 R - GTH 4018 R - GTH-5021 R Part No. 57.0009.0607
Second Edition - First Printing
Operating Instructions
Job-Site/Road/Platform Select
•
Job-site mode: all machine functions are
enabled;
•
Road transfer mode: boom movement, turret
rotation and outriggers movements are
disabled; only the two-wheel steering mode is
enabled;
•
Platform mode: all controls from the cabin are
disabled, operate the machine by the platform
controls.
If the chassis is not levelled, the
platform doesn't work.
Operator Descent With 90°
Slewing Upper Structure
When the slewing upper structure is rotated, the
operator can descend from the machine through
the two dedicated iron steps located at the front
and rear of the chassis.
Always hold to the dedicated handholds to
prevent falls or slips.
Raising and Lowering the
Outriggers
Push the top of the rocker switch to extend/lower
the outriggers. Push the bottom of the rocker
switch to raise/retract the outrigger.
Before operating the outriggers, when the
slewing structure is not aligned, verify that the
outrigger control corresponds to the correct
outrigger.
Levelling the chassis ( if
equipped)
Push the right side of the rocker switch to lower
the right side of the chassis. Push the left side
of the rocker switch to lower the left side of the
chassis.
Emergency Exit
Pull the retaining pins and push out the window.
