44 GTH-4016SR • GTH-4018SR Part No. 57.4400.9203
March 2010
Section 4 • Repair Procedures
REV A
25. fix the hydraulic hoses to the hoses holder
block (
20
);
26. Follow these instructions to register the
chains:
•
for the lower side chains, completely
extend the boom and then retract it of
1 meter. Torque the chain tentionair to
50N/m;
•
for the upper side chains, completely
retract the boom and then extend it of
1 meter. Torque the chain tentionair to
50N/m.
WARNING
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting
this procedure without these skills
and tools could result in death
or serious injury and significant
component damage. Dealer
service is strongly recommended.
NOTICE
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation.Refer to
paragraph “
Hydraulic Hose and
Fitting Torque Specifications”
into
Specification Section
BOOM COMPONENTS
