April 2019
First Edition - Fourth Printing
Part No.
57.0009.0729
GTH-4014 AU, GTH-4018 AU
31
Test the Outriggers Cutout
30 Raise the boom over
25° and extend over 0.5
meters. Attempt to deploy or retract outriggers.
Result: The outriggers should not work.
31 Fully retract and raise the boom over 50° (GTH-
4014 AU) or 40° (GTH-4018 AU). Attempt to
deploy or retract outriggers.
Result: The outriggers should not work.
Test the Road Transfer Mode
32 Set the steer select switch to road transfer mode.
33 Attempt to: operate the boom and extend/lower
the outriggers functions.
Result: None of these functions should operate.
Test the Levelling Cutout
34 Raise the boom over 25° and extend over 0.5m
Slowly level the machine to the left and to the right.
Result: The levelling function should not operate.
35 Fully retract and raise the boom over 50° (GTH-
4014 AU) or 40° (GTH-4018 AU). Level the
machine to the left and to the right.
Result: the levelling function should not operate.
Test the Lights
36 Verify that all equipped working and road lights
are functional.
Test the Load Management System
37 Load a known weight of approximately 1000 kg.
38 Raise the boom about 30 cm above the ground.
Inspections
39 Extend the boom and check if the system enters
the alarm mode once it has reached the distance
as indicated in the load charts for the attachment
fitted to the machine.
Result: the system alarm mode should sound
and boom movement stop.
Test the Joystick Enabling Function
Switch
40 Operate the joystick without pressing this button.
Result: the joystick shall not activate any
movement.
Test the Emergency Stop Push button
41 Press the Emergency Stop Push button down
during a movement.
Result: the movements shall stop and engine
should shut down.
Test the LMS front and rear camera (if
fitted)
42 Login to LMS.
43 On the display screen, press the reverse camera
enable button located at the bottom right corner
of the screen.
Result: the screen should display a live broadcast
from the reversing camera.
44 Using the boom functions joystick, raise the boom
a few centimeters from the ground.
Result: The screen should momentarily switch to
home screen view while the boom is in motion
and then revert to rear camera view when the
boom movement is complete.
