April 2019
76
GTH-4014 AU, GTH-4018 AU
Part No.
57.0009.0729
First Edition - Fourth Printing
Attachments
Fixed Hook
(part number AUS 10011)
TECHNICAL DATA
Payload
4000 kg
Width
990 mm
Length
615 mm
Height
510 mm
Weight
150 kg
The fixed hook has been designed to support a
load of 4000 kg. The max payload corresponds
to the nominal capacity rating of the telehandler
on which it is installed and may be reduced as
indicated on the load charts supplied with the
equipment.
Application
Quick-coupling fitted attachment for lifting loads by
means of special slings.
Safety
Strictly obey the general safety precautions given in
section “Safety”.
Do not oscillate the load.
Do not drag hooked loads.
Lift the load before extending the boom.
Operation
Fork the hook and hold it in position by means of the
locking cylinder.
All loads must be bridled with special textile slings or
chains in compliance with all pertinent regulations.
To handle the load, raise and rotate the telescopic
boom of the handler.
Maintenance
Visually check the hook for damage before using
it. Check the safety catch is in good working order.
• Capacity is in accordance with the load chart
supplied for this attachment
• Load must be kept low while travelling - use
short slings
• Pick and carry position
-max boom angle 35°
-boom fully retracted
-maximum drive speed 0.4 m/s (walking speed)
-maximum downhill slope 5°
-maximum sidewards slope 5°
For use of this attachment, refer to “suspended
load Hazard” section
