April 2019
First Edition - Fourth Printing
Part No.
57.0009.0729
GTH-4014 AU, GTH-4018 AU
77
Attachments
2 m Extension Jib
(part number AUS100020)
TECHNICAL DATA
Payload
3000 kg
Width
1000 mm
Length
2225 mm
Height
675 mm
Weight
205 kg
The 2 m extension jib has been designed to
support a load of 3000 kg. The max payload
corresponds to the nominal capacity rating
of the telehandler on which it is installed and
may be reduced as indicated on the load
charts supplied with the equipment.
Application
Quick-coupling fitted attachment for lifting loads
by means of slings.
Safety
Strictly obey the general safety precaution given
in “Safety” chapter.
Never lift incorrectly slung loads.
Avoid abrupt acceleration or deceleration.
Avoid load oscillations, and especially do not
move the load from the vertical pull line.
Do not pull crosswise and do not tow.
Operation
Couple the jib and hold it in position by means of
the locking cylinder. All loads must be lifted with
slings or chains in compliance with all relevant
regulations. To handle the load, raise and rotate
the telescopic boom of the telehandler.
Maintenance
Visually Check the jib for damage before using it.
Check the safety catch is in good working order.
• Capacity is in accordance with the load
chart supplied for this attachment
• Load must be kept low while travelling-
use short slings.
• Pick and carry position
-max boom angle 35°
-boom fully retracted
-maximum drive speed 0.4 m/s (walking
speed)
-maximum downhill slope 5°
-maximum sidewards slope 5°
For use of this attachment refer to “Suspended
Load Hazard” section.
