Sixth Edition • First Printing
Operator's Manual
Transport and Lifting Instructions
Part No. 1298036GT
IWP
®
Super Series
39
Trans port and Lifti ng I nstr ucti ons
Transport Instructions
Observe and Obey:
Common sense and planning must be applied
to control the movement of the machine when
lifting it with a crane or forklift.
The transport vehicle must be parked on a
level surface.
The transport vehicle must be secured to
prevent rolling while the machine is being
loaded.
Vehicle capacity, loading equipment and
surfaces must be capable of supporting the
machine weight. See the serial plate for the
machine weight.
The base of the machine must remain lowered
during all loading and transport procedures.
The machine must be securely fastened to the
transport vehicle. Use chains or straps of
ample load capacity.
Winching the Machine onto a
Flatbed Truck
1
Fully lower the platform.
2
Push in the red Emergency Stop buttons, turn
the key switch to the off position and remove
the key.
3
Inspect the entire machine for loose or
unsecured items.
4
Connect the cable to the winching point
located on the front of the base.
5
Carefully winch the machine onto the truck.
6
Secure the machine base and mast to the
transport vehicle. Use chains or straps of
ample load capacity.
Loading the Machine With a
Forklift
Use the forklift pockets located on the sides of the
machine or the forklift rings located behind the
counterweight under the platform.
Be sure to inspect the machine and remove any
loose or unsecured items.
To use the forklift rings:
1
Raise the platform
3 inches / 7.5 cm.
2
Position the forklift
rings in the up
position.
Summary of Contents for Genie IWP Series
Page 44: ......
