Operator's Manual
Sixth Edition • First Printing
Operating Instructions
32
IWP
®
Super Series
Part No. 1298036GT
Operati ng I nstr ucti ons
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator’s
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
5 Only use the machine as it was
intended.
Fundamentals
The Operating Instructions section provides
instructions for each aspect of machine operation.
It is the operator’s responsibility to follow all the
safety rules and instructions in the operator’s,
safety and responsibilities manuals.
Using the machine for anything other than lifting
personnel, along with their tools and materials, to
an aerial work site is unsafe and dangerous.
If more than one operator is expected to use a
machine at different times in the same work shift,
each operator is expected to follow all safety rules
and instructions in the operator’s manual. That
means every new operator should perform a
preoperation inspection, function tests and a work
place inspection before using the machine.
Setup
1
Pump the foot pedal
to raise the base until
the wheels contact
the ground.
2
Use the steering handle to push the machine.
3
Position the machine on a firm, level surface
directly below the work area.
4
Pull the base lowering
handle to lower the
base until all four
footpads are in firm
contact with the
ground.
5
Connect to the appropriate power source.
DC models: Connect the battery pack.
AC models: Connect to a grounded 15A AC
power supply. Use a 12 gauge / 3.3mm
2
3-
wire grounded extension cord no longer than
50 feet / 13 m.
6
Insert the key and turn to platform control.
7
Pull out the red Emergency Stop button at the
ground controls and be sure the power light is
on.
Summary of Contents for Genie IWP Series
Page 44: ......
