First Edition • Second Printing
Operator's Manual
Inspections
Part No. 1270491
Z-60/37DC • Z-60/37FE
37
69
Return to level ground and stow the boom.
70
With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 2.5°.
Result: The machine should continue to drive.
71
Return to level ground and raise the secondary
boom to an out of stowed position
(approximately 15° above horizontal).
72
Drive the machine onto a slope where the
chassis pitch angle is greater than 2.5°.
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the
alarm should sound at the platform controls.
73
Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
74
With the boom fully stowed, drive the machine
onto a slope where the chassis roll angle is
greater than 4.5°.
Result: The machine should continue to drive.
75
Return to level ground and raise the primary
boom to an out of stowed position
(approximately 10° above horizontal).
76
Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
77
Lower the primary boom to the stowed position
or drive in the opposite direction.
Result: The machine should drive.
78
Return to level ground and extend the primary
boom approximately 0.5 m.
79
Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
80
Retract the primary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
81
Return to level ground and stow the boom.
82
With the boom fully stowed, drive the machine
onto a slope where the chassis roll angle is
greater than 4.5°.
Result: The machine should continue to drive.
83
Return to level ground and raise the secondary
boom to an out of stowed position
(approximately 15° above horizontal).
84
Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
85
Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
