December 2018
Service and Repair Manual
Platform Controls
Part No. 1271125GT
Z®-60/37 DC • Z®-60
/37 FE
17
14 Press down on the foot switch and select the
toggle switch controlled boom function to be
adjusted.
Result: The display will indicate the parameter
in milliamps while operating the function.
15 Momentarily activate the speed select switch
in either direction while operating the function
(foot switch depressed) to achieved the
desired threshold value. Do not release the
foot switch.
16 Momentarily activate the drive enable toggle
switch in the right direction to save the value.
Result: The alarm will sound indicating the
setting has been saved. Release the foot
switch. Continue to the next threshold current
adjustment.
To exit programming mode:
17 Move and hold the drive enable toggle in the
left position until the display returns to
SYSTEM READY mode.
How t o Adj ust t he Joystic k Max- out Set ting
How to Adjust the Maximum
Speed Setting (Hydraulic
Functions)
There are three types of speed settings to adjust:
High Flow Functions:
Primary Up/Down Primary
Extend/Retract, Secondary Up/Down and
Turntable rotate.
Low flow Functions
: Jib Up/Down, Jib rotate, and
Platform rotate.
Other Functions:
Steering is set by a fixed flow
regulating valve (non adjustable), Platform level
(adjusted by a needle valve located on the function
manifold) and Hydraulic Valve Ramps. Refer to
How to Adjust Ramp Rate Setting.
Note: Refer to Specifications,
Performance
Specifications,
for each boom function speed.
Check function pump calibration before adjusting
the maximum speed setting. Refer to Repair
Procedures,
How to Check Function Pump
Calibration
.
1
Turn the key switch to platform control.
2
Pull out the red Emergency Stop button to the
'ON' position at both the ground and platform
controls.
3
Do not press down the foot switch.
4
Move and hold the drive enable toggle switch
in the right direction while holding steer in the
right direction.
5
When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer joystick.
Result: The display will show FAULTS.
6
Momentarily activate steer in the right direction
until SETTINGS is shown on the display.
7
Momentarily activate the drive enable toggle
switch in the right direction until VALVE AND
SENSOR SETTINGS is shown on the display.
Summary of Contents for Genie Z-60 DC
