INDEX
GYRO 4020 - 4518
SAFETY
1
4
Document 57.4402.8200 - 1
st
Edition 03/2007
1.2
GENERAL REMARKS
Most accidents occurring while working, servicing or
maintaining operation machines, are caused by not
complying with the basic safety precautions.
Therefore, it is necessary to pay steady attention to
the potential hazards and the effects that may come of
operations carried out on the machine.
If you recognise hazardous situations, you can
prevent accidents!
For instance, this handbook makes use of special
safety
symbols
to highlight potentially hazardous situations.
The instructions given in this handbook are the ones
established by GENIE. They do not exclude other
safe and most convenient ways for the machine
commissioning, operation and maintenance that take
into account the available spaces and means.
If you decide to follow instructions other than those given
in this manual, you must:
•
be sure that the operations you are going to carry
out are not explicitly forbidden;
•
be sure that the methods are safe and in compliance
with the indications given in this section;
• be sure that the methods cannot damage the machine
directly or indirectly or make it unsafe;
• contact GENIE Assistance Service for any suggestion
and the necessary written permission.
Do not hesitate to pose questions if you are in
doubt! Contact GENIE: the assistance service is at
your disposal. Addresses, phone and fax numbers
are given in the cover and in the title-page of this
manual.
1.3
SERVICEMEN'S REQUISITES
The operators who use the machine regularly or
occasionally (e.g. for maintenance or transport) shall
have the following requisites:
health:
before and during any operation, operators shall never
take alcoholic beverages, medicines or other substances
that may alter their psycho-physical conditions and,
consequently, their working abilities.
physical:
good eyesight, acute hearing, good co-ordination and
ability to carry out all required operations in a safe way,
according to the instructions of this manual.
mental:
ability to understand and apply the rules, regulations and
safety precautions. They shall be careful and sensible
for their own as well as for the others’ safety and shall
desire to carry out the work correctly and in a responsible
way.
emotional:
they shall keep calm and always be able to evaluate their
own physical and mental conditions.
training:
they shall read and familiarise with this handbook, its
enclosed graphs and diagrams, the identification and
hazard warning plates. They shall be skilled and trained
about the machine use.
It is recommended to take part in at least one technical
training course organised by GENIE Assistance
Office.
Ordinary and extraordinary maintenance of the
machineare quite complex from a technical point
of view and should be performed by an authoirsed
service centre.
