Document 57.4402.8200 - 1
st
Edition 03/2007
INDEX
GYRO 4020 - 4518
TECHNICAL SPECIFICATIONS
2
38
2.24 SETTING THE OVERLOAD WARNING
SYSTEM
1. Start the engine and before the audible alarm of
the overload warning system stops sounding, press
ENTER
and type in the password
4482
acting on
INDEX
to move the cursor on the digits.
2. The display will ask to confirm the equipment "forks".
Press
ENTER
and then, by means of the
+
key, find
and open page
55 OUTRIGGER IN
and make sure
that the outriggers are fully retracted; then press
ENTER
and
INDEX
to confirm.
3. Press key
+
several times until displaying page
56
OUTRIGGER OUT
and then extend all the outriggers
and press
ENTER
and
INDEX
to confirm.
4. Press key
+
several times until displaying page
57 ROTAX
; move the turntable to the 0-degree
position, lock in place with the pin and then press
ENTER
and
INDEX
to confirm.
5. Press key
+
several times until displaying page
58
LEVELLING
and, using a spirit level, make sure
that the machine is level with the two axes, then
press
ENTER
and
INDEX
to confirm.
6. Stabilise the machine and, by pressing key
+
several
times, open page
2 TRANSDUCER MIN
. Lower
and retract the boom completely and then press
ENTER
.
7. Press key
+
several times until displaying page
3 TRANSDUCER MAX
and, once the machine
is stabilised, raise the boom up to the maximum
angle (check that the boom reaches the max height
by turning the load limiter inhibition key) and then
extend the boom to max length and then press
ENTER
.
8. Press key
+
several times until displaying page
0
SAVE
and then press
ENTER
and wait until the
message
DONE
is displayed.
Wait for some 2 minutes and then turn off the
machine.
9. The first setting phase is completed. Now test all the
possible configurations with different weights and
make sure that the values given in the load charts in
the driving place are respected.
