Document 57.4402.8200 - 1
st
Edition 03/2007
INDEX
2
49
GYRO 4020 - 4518
TECHNICAL SPECIFICATIONS
Now the network is configured. Unless the set parameters
are changed, you shall not repeat this procedure on
your PC.
At this point, install the
WINSCOPE
programme on your
PC.
The settings are loaded by TEREXLIFT during the
machine assembly (e.g.: movement speeds, ramps,
etc.).
These data have been empirically evaluated and
vary from a machine model to the other; they can
changed at any times and for each machine, if
necessary.
Installing
WINSCOPE
This programme lets you carry out a number of
adjustments, including the adjustment of the movement
speeds and the ramps.
When you use the programme the very first time, you
shall configure the same.
Select the
Prj Selection
item from the
Utils
menu.
Select the position of the
CFG.IT
file or press the
Browse
button to search for the same on your PC.
Selecting this file lets you load the menus and parameters
of the machine to be used.