Document 57.4402.8200 - 1
st
Edition 03/2007
INDEX
2
71
GYRO 4020 - 4518
TECHNICAL SPECIFICATIONS
Display of equipment and operating mode
If the accessory is preset for automatic recognition
(presence of the polarisation connector), the equipment
change occurs automatically and the system self-
recognises the accessory used.
If the accessory is not preset for automatic recognition,
the selection is done by hand by selecting the correct
Chart (I) from the panel.
The setting of the Operating Mode (LT) is automatic and
selected by external micro-switches.
In the main page (the one usually displayed), the Chart
of the selected equipment (I) and the Operating Mode
(LT) of the machine are displayed in the highlighted zone
under form of digits.
In the example in the picture, the displayed working
condition is:
LT = 1
Front outriggers
I = F
Forks.
As for the symbols on the panel, the possible selections are as follows:
LT main selections (automatic):
1 = Outriggers - front
2 = Outriggers - side
3 = Wheels - front
4 = Wheels - side
I selections from panel (manual):
F = Forks
P = Platform (basket)
W = Winch
J = Jib
R = Robot
2.2
4.0
6.1
1 F
