10.
Slide the pump forward and lift out of the machine
utilizing the lifting device (11-15).
Installation
1.
To install the tandem pump, reverse the removal
procedure.
Note:
Torque the tandem pump mounting bolts to
200
lb. ft. (
271
Nm) and use blue
Loc-tite
or equivalent to
secure the bolts in position.
Drive Motor
Removal
1.
Remove the track from the undercarriage by
performing the track removal procedure from page
4-6 of this manual.
2.
Remove the sprocket from the undercarriage by
performing the sprocket removal procedure from
page 4-5 of this manual.
Note:
Label the drive hoses, drive motor and drive
table to ensure correct installation and proper
orientation during reassembly.
3.
Remove the hoses from the drive motor through
the cavity of the drive table (fig. 11-17). Remove
the two large adapters for ease of access to the
remaining components. Be sure to cap and plug
the ends of the hoses to prevent contamination.
4
. Remove the socket head bolts that secure the
drive motor to the drive table as shown in
in figure 11-18.
11-5
Compact Track Loader
11. Hydraulic Pumps/Motors
11-15
Required Tools
Combination/Socket Wrench
Impact Wrench
3-Jaw Puller
Snap Ring Pliers
Hammer/Mallet
11-16
Drive table
Drive motor
11-17
11-18
Summary of Contents for PT100G Forestry
