Compact Track Loader
8. Hydraulic Reservoir
Disassembly and Assembly
8-6
Reservoir Gauge Installation
Figure 8-20
1.
Install the reservoir gauge in the reservoir using
the two mounting bolts/washers.
Figure 8-2113
2.
Reach inside the reservoir and install the two
nuts that secure the reservoir gauge to the res-
ervoir.
3.
Install the filter assembly. Refer to
Chapter 8.
Filter Assembly Installation
.
4.
Add manufacturer-approved hydraulic fluid.
Suction Screen Removal and
Installation
The tools required for suction screen removal and
installation are listed in Table 8-4. Use manufactur-
er-recommended tools whenever possible.
Table 8-4
Required Tools
Combination Wrench
Suction Screen Removal
Hot oil can cause personal injury. Make sure the
oil is cool before removing any components or lines.
Remove the oil filler cap only when the engine is
stopped and the machine has been allowed to cool
thoroughly
Collect and contain liquids in a suitable contain-
er. Dispose of all liquids according to local regula-
tions and mandates.
Note
: It is normally not necessary to replace the suction
screen unless there has been a catastrophic failure and
there is debris in the reservoir.
1.
Drain the hydraulic fluid. Refer to
Chapter 13.
Hydraulic Fluid and Filter Change.
2.
Remove the access cover assembly. Refer to
Chapter 8.
Access Cover Assembly Removal
.
Figure 8-22
3.
With a magnet centered in an absorbent rag,
thoroughly clean the interior of the reservoir to
prevent any debris from entering the system
when you remove the suction filter.
Insert Reser-
voir Gauge
with Mounting
Bolts/Washers
