TECH TIP 192 | RELEASED 11.17.2022 | VERSION 1.0
STEP 5
Verify that the Viatec symbol on the bottom left
of the screen displays detected. If the system
is detected, press the PTO button.
FIGURE 8
FIGURE 9
FIGURE 7
STEP 6
Verify that under the viatec symbol the wording
changed from Detected to Allowed. This lets the
operator know that all the interlocks have been
met to allow the system to run.
Figure 8
Then press the E-PTO buttom. It will turn
yellow during start-up and then will turn green.
Once the motor can be heard turning, the smart
PTO system is ready to use.
Figure 9
If any faults are detected, consult the
manufacturer’s manual for troubleshooting. If
you have any questions call 1-844-TEREX4U
(1-844-837-3948) or email
PAGE 6 OF 7
