Safety and Prevention of Accidents
2
TC29
13
The engine/motor(s) must be turned off prior to all
maintenance and repair work. These requirements
are only to be ignored in the case of maintenance
or repair work which cannot be performed without
the engine/motor(s) running.
When performing maintenance and repair work on
the hydraulic system, the hydraulic system must be
relieved of pressure. With the engine turned off,
lower the work equipment to the ground and
actuate all hydraulic control levers until there is no
pressure in the hydraulic system.
Before working on the electrics or when performing
arc-welding on the machine, the connection to the
battery must be interrupted.
When disconnecting the battery, first the negative
pole then the positive pole must be disconnected.
The battery must be re-connected in reverse order.
During repair work around the battery, the battery
must be covered with insulating material. Tools
should never be placed on or near the battery.
Protective devices of moving machine parts are
only to be opened or removed when the drive has
been switched off and cannot be switched on
again by unauthorized persons. Protective devices
are e.g. engine/motor covers, doors, protective
grating, trim.
Upon completion of assembly, maintenance or
repair work, all protective devices must once more
be attached in the proper manner.
Load-bearing parts of earth-moving machines are
only to be welded following consultation with the
manufacturer and in accordance with recognized
welding principles.
Protective structures (TOPS, ROPS; FOPS) are
not to be welded or drilled in any way.
Alterations, such as welding of the hydraulic
system, are only to be undertaken with the
manufacturer’s permission.
Before commencing work on the hydraulic system,
the operating pressure, pilot pressure, back
pressure and pressure inside the tank must be let
off.
Swallowing lubricants as well as long and repeated
skin contact can be hazardous to health and
should therefore be avoided. When used properly,
there is no particular danger to health. The safety
specification sheets from the mineral companies
must be observed.
Only the hoses specified by the manufacturer may
be used.
Hydraulic hoses must be routed and assembled by
expert personnel.
In the vicinity of fuel or batteries, smoking and
naked flames are prohibited.
2.18 Recovery, loading, transportation
Earth-moving machines are only to be loaded onto
recovery vehicles when adequate towing vehicles
are used.
The tow fixing points specified by the manufacturer
must be employed.
For loading and transportation, earth-moving
machines and all necessary auxiliary equipment
must be secured against unwanted movement.
The travelling gear and crawler unit of earth-
moving machines must be sufficiently cleaned of
mud, snow and ice to ensure that ramps can be
driven up without risk of slipping.
When transporting the earth-moving machine on
trucks, flatbed trailers, or by rail, it must be
sufficiently secured with chocks and by attachment
to the lashing points.
Before setting off, the route to be taken must be
examined to determine whether the roads are wide
enough, entrances and passages under bridges
are large enough and that roads and bridges have
sufficient carrying capacity.
Summary of Contents for TC29
