D E L I V E R Y A N D H A N D I N G - O V E R I N S T R U C T I O N S
The following checklist is to be adhered to when handing over the machine
to the customer:
1. Operating instructions
The operating instructions should be read side by side, and be explained in
detail through practical training on the machine.
The following items are of special importance:
•
Regulations for preventing accidents published by the employer’s
liability insurance associations in the user’s country
•
Technical
data
•
Operator controls, control and warning indicators
•
Checks before putting the machine into operation
•
Specifications for diesel engine start-up
•
Switching on and off the diesel engine
•
Explanation of hydrostatic crawler drive
•
Travel
operation
•
Recovery and transport of the machine
•
Operation of all functions
•
Tensioning the crawler chains
•
Explanation of maintenance and inspection intervals according to
Maintenance and Inspection Plan by demonstrating maintenance points
on machine
•
Lubrication intervals and points of lubrication according to overview of
lubricating points and demonstration of these points on the machine
•
Handing over the diesel engine operating instructions
2. Spare parts list
•
Structure of spare parts list, of figures and the respective descriptions
•
Instructions for ordering spare parts: always state the type of machine,
the vehicle identification number (Fz-Id.Nr.), parts designation, complete
spare part number, piece number, delivery address, etc.
3. Warranty
•
Explanation of warranty covered by manufacturer
•
Explanation of inspection cards and note on maintenance and
inspection plan
•
The warranty/ handing-over card must be filled out correctly and sent
back
Crawler Excavator
TC29
Maintenance and Inspection Plan
The careful performance of all prescribed inspections is the best prerequisite
for the machine’s continuous readiness for operation.
All maintenance work mentioned should therefore be performed in the
prescribed sequence with the machine at operating temperature.
The inspections are obligatory.
If omitted, the warranty covered by us may be subject to restrictions.
The machine must be thoroughly cleaned before inspection takes place.
Summary of Contents for TC29
