Document 57.4400.7200 - 1
st
Edition 03/2005
INDEX
4
21
TELELIFT 3713 Elite - 4017 - 4514
SCHEDULED MAINTENANCE PROCEDURES
■
Checking the proximity switches
(at every use)
Sensor L on the boom (only Telelift 4017-4514)
• Raise and tilt the boom more than 40° and check
if the axle is blocked.
Should this not be the case, contact the Terexlift
Technical Service Centre.
Sensor M on the boom
• Raise the boom beyond the horizontal and ensure
the sway control and the outrigger conttrol are
blocked.
Should this not be the case, contact the Terexlift
Technical Service Centre.
If the trouble does not depend on the sensor adjustment,
contact the Terexlift Technical Service Centre.
■
Checking the pressure switch N on the parking
brake (Telelift 4017-4514)
(at every use)
To check the efficiency of the pressure switch on the
parking brake, proceed as follows:
• Sit on the driving place, put the parking brake and
attempt to move with the machine. The machine
must stand still.
Should this not be the case, contact the Terexlift
Technical Service Centre.
■
Checking the microswitch O on the parking brake
(Telelift 3713 Elite)
(at every use)
To check the efficiency of the microswitch on the
parking brake, proceed as follows:
• Sit on the driving place and attempt to start the
machine without engaging the brake. The machine
must not move. Shoudl this not be the case, adjust
the distance of the brake microswitch or replace
it.
Left side
Right side
Telelift 4017-4514
Telelift 3713 Elite
Only Telelift 4017-4514
N
M
O
L
Summary of Contents for TELELIFT 3713 Elite
Page 4: ...Courtesy of Crane Market...
