Document 57.4400.7200 - 1
st
Edition 03/2005
INDEX
5
21
TELELIFT 3713 Elite - 4017 - 4514
TROUBLESHOOTING
Trouble
Cause
Solution
Wiper motor
M13
damaged
Fuse
F1
damaged
Washer control
SX11
damaged
Washer motor
M91
damaged
Fuse
F23
damaged
Lamps damaged
Fuse
F25
damaged
Display damaged
Display damaged
Tecnord control unit damaged
Outrigger limit switches (
S51
and
S52
)
damaged
Check you have 12V on connector
X13
to pin
3
, and, with selecting the two
speeds one at a time, check there is
power on pins
2
and
4
of connector
X13
. If necessary, change the motor.
Check the fuse and replace if
necessary.
Check you have 12V on connector
X11
to pin
1
and, with the button pressed,
check that pin
7
is powered; or change
the button.
With the button pressed, check you
have 12V between the two contacts of
the motor; or change the motor.
Check the fuse and replace if
necessary.
Check you have 12V on pin
5
of
connector
X8
; or change the lamp.
Check the fuse and replace if
necessary.
Check you have 12V between pins
1
and
2
of the connector; or change the
display.
Check you have 12V between pins
1
and
2
of the connector; or change the
display.
Check you have 12V on pin
4B
of
connector
XJ1
; or change the control
unit.
Lower the outriggers to the ground and,
with a tester, check that the two NO
contacts of the limits switches are
closed. Check you have 12V on pin
10
of connector
X22
.
If necessary, change
the limit switches.
The windscreen washer does not
function
The cab interior lights do not
function
The display of the overload warning
system does not turn on
The machine is in alarm and lets you
operate only the lowering and
retraction movements (without
displaying any alarm codes)
The display does not change the
reading scale when you switch from
machine on wheels to machine on
outriggers
Summary of Contents for TELELIFT 3713 Elite
Page 4: ...Courtesy of Crane Market...
