Operating Your TERK TV5 Low-
Profile Indoor Amplified Antenna
For VHF and UHF:
1. Switch video selector switch to “Antenna”.
2. Tune your TV to the desired station.
3. Holding the top of the center control arm, simply
rotate the antenna to seek the best quality picture.
4. Adjust the “amplification”slider for the best picture
and sound
For Video Games and Other Video Components:
1. Attach the coaxial cable from your satellite, cable, or
video game adapter to the video input on your TV5.
Ensure a tight fit to avoid interference.
2. Switch the video selector switch to “Video” for operation.
3. To connect a DVD player, VCR or video game system to
a television that is not equipped with A/V jacks, you will
need to obtain one of TERK’s RF modulators.
TV5
4
Installation
(continued)
Connecting your TV5
There are two ways to connect your TV5. This will depend
on your model of television.
For Televisions with One 75 Ohm Input for VHF and UHF:
1. Connect the coaxial cable from your TV5 to the
“F” connector input marked VHF/UHF on your TV.
See Fig 2.
For Televisions with Separate 75 Ohm
VHF and UHF Inputs:
1. Attach the band separator (not included) to the coaxial
cable attached to the back of your TV5.
2. Screw in the VHF connector from the band separator to
the VHF input on your TV or VCR.
3. Attach the 300 ohm twin wire from the band separator
to the two screws marked UHF.
See Fig 3.
Powering your TV5
Attach the AC adapter (included) to the DC input on the
rear of your TV5. Plug the other end of the adaptor into
any 12 volt AC outlet.
TV5
3
