Page 47/62
Rev. A
2017-12-04
SCANTER 1002 Radar System
User’s Manual
1255194-HO
Name
Min
Max
Severity
Description
Drive/Motor Initialization Er-
ror#Motor Controller
Error
Duty Cycle Error
Error
EEPROM VCO Multiplier Config-
uration Missing
0 0
Error
Indicates that the VCO multiplier configuration is not stored in
the LRU EEPROM of the RxTx LRU. A 2x multiplier configu-
ration is assumed, which will lead to garbled radar video if
used with a 4x multiplier unit. The correct setting is available
from the operation sheet of the RxTx LRU and may be pro-
grammed in the LRU EEPROM from the debug www page
Enable Status Of Drive/Motor
Disabled#Motor Controller
Error
Failure Override Enabled Warning
Warning
Fault#Motor Controller
Error
FFT Bandwidth Exceeded Error
Error
Filter Coefficients Calculation
Error
Error
An error occurred during calculation of filter coefficients
FPGA Temperature Error#FPGA0
90.0
500.0
Fatal
Error
Indicates that the FPGA core temperature is outside the al-
lowed range and that Mains has been turned off to prevent
component damage
FPGA Temperature Warn-
ing#FPGA0
85.0 90.0
Warning
Indicates that the FPGA core temperature is outside the rec-
ommended range
Hall Sensor Missing/Resolver
Error/BiSS Error/Pos Wrap Around
Error#Motor Controller
Error
Invalid HDL PEX Input#Air
Error
The HDL PEX has delivered erroneous data within the last
scan to the PlotServer.
I2T Protection Error#Motor Con-
troller
Error
Long Chirp Length Truncated
Warning
Warning
Low Disk Space Error
Error
Low Disk Space Warning
Warning
Maximum Track Latency Exceeded
Warning
The maximum processing latency for track generation through
the tracker has been exceeded.
Missing frequency in PSAT Cali-
bration Table Error
Error
PSAT calibration table not complete for this profile, rerun
PSAT calibration for this profile
Motor I2T Protection Warn-
Warning
