Page 8/62
Rev. A
2017-12-04
SCANTER 1002 Radar System
User’s Manual
1255194-HO
In no event, Terma A/S shall be held liable for any direct, indirect, punitive, incidental or consequential damages what-
so-ever arising out of or connected with the use or misuse of its products.
Only maintenance for authorized personnel.
This radar produces low power non-ionising electromagnetic radiation. Radiation is normally
not dangerous for the human body, however precautions should be taken, and a safety
distance of 1 meter when operating should be kept.
Always disconnect power before maintaining the radar. The rotating antenna may cause
injury.
Part of the equipment may have hot surfaces. Precautions should be made.
MAINTENANCE OF THE RADAR SYSTEM
WARNING
SAFETY
FIRST
WARNINGS,
CAUTIONS AND
SAFETY
INSTRUCTIONS
AUTHORIZED
PERSONNEL
ONLY
CAUTION
CAUTION
High voltage may be present at several points of the equipment. Observe and follow all
electrical safety precautions. These voltages may cause injury or even death.
When maintaining The radar, radar and instruments must be connected to the same electrical
protective ground.
Always use ESD (Electrostatic Sensitive Device) precautionary procedures when handling
ESD marked modules. The equipment contains components sensitive to damage by
electrostatic discharge. Wrist strap connected to earth bonding point must always be used
when handling unshielded electronics. Modules must be stored in static shielding packaging
(EIA-541). Module repair must be done on a ESD workstation, by qualified personnel.
Equipment weighs about 35 kilograms and to avoid injury, use proper lifting technique, 2
person lifting or lifting aids.
WARNING
