“VT-TMP” heating constant temperature bath Operating manual
This manual provides the information needed to operate heating constant temperature bath
“VT-TMP”.
INTRODUCTION
Intended use
Heating constant temperature bath is intended for standard test method for corrosiveness to
copper from petroleum products by copper strip test according to ASTM D130 and ISO 2160.
Appearance and parts names
3
Heating constant temperature bath “VT-TMP” consists of:
1 -
Heating immersion circulator “M01”;
2 -
Stainless steel bath tank with adapter for test thermometer 3.
Heating immersion circulator 1 includes a
rotary pump, a heater, a temperature sensor, an
output pipe for thermal fluid circulation and a
built-in cooling coil.
Place base 3 with vessels 4, which are in-
tended for running a copper strip test of petro-
leum products, or test tubes inserted in stand 6,
inside operating bath 5, located in the bath tank.
3
4
5
2
1
3
