7
DESCRIPTION AND DESIGN
The stove body is an all-welded structure of rectangular shape.
The firebox is made of heat-resistant high-alloy stainless steel, 0.08” (2 mm) thick, consisting not less than
13% of chromium.
Thanks to this stove walls get hot quickly and quickly begin to warm the heated area. The use of this
material allows significantly reduce the weight and increase the efficiency of the device.
Picture 2.General view and components of the stove INDIGIRKA-2
Chromium forms a passive skin on the surface of the stove and makes it chemically inert. This minimizes
such undesirable effect, as a burnout of oxygen in a heated area.
The grate is made of a sheet of heat-resistant high-alloy stainless steel 0.12” (3 mm) thick and is designed to
force the burning process and get a powerful high-temperature flame.
Stove components, which do not carry a large thermal working load, are made of structural steel of 0.06”
(1.5 mm) thick.
Two Thermoelectric Generators B25-12 (further TEG) (8) are installed on the side surfaces. The
specification of the generator is in your TEG passport. At the bottom part of the stove, on the non-rising
Chassis, there is a TEG Control Unit (6), consisting of a Control Unit and a group of Clamp Outlets.
Connectors for electrical consumers are located on the exterior walls. On one side there is a Power Outlet
12V Connector (9) (like a cigarette lighter in a car) to which could be connected a T-joint outlet.