•
First connect the sensor (male thread 1/2”) on the marked position on the boiler - female thread
1/2”
•
Now connect the cold water supply to the valve - female thread 3/4”, then connect the valve to the
position 1 (cold water entrance), the boiler should have the prepared reduction 3/4”-1/2”
•
Connect the hot water exit toward the sewerage.
10
Boiler cleaning and maintenance
Do not clean the boiler while boiler is in operation. Perform cleaning only when boiler is off and
is completely cold! The use of gloves is obligatory.
It is recommended that the boiler is cleansed from ash once to two times weekly. A detailed cleansing
of the boiler should be done once a month and also when the heating season ends. Regular maintenance
extends the service life of the boiler.
Beside the heating chamber it is also necessary to clean the area below the oven. To access this area,
please open the woodlog storage (Position 1) then unscrew the holders (Position 2 and 3).
It is also necessary to clean the area below the heating plates by simply lifting the heating plates.
Please pay attention that heating plates may fall down and hurt you.
17
Summary of Contents for Temy Plus P 20
Page 3: ...1 Technical data 2 ...
Page 4: ...3 ...
