13
2 - INSTALLATION
2.1 Before installing
In order to start the hot air generator
easyTERM
, the following conditions are required:
• connection to the electric power supply with voltage and frequency suitable for the machine and with grounding
and safety devices;
• the machine
is preset and is sold to work with natural gas (methane).
In case of use with LPG, you must
refer to cap. 4.2 for instructions. Connection to the suitable gas supply (see technical details);
The installation must meet the safety requirements
provided by local regulation in force.
Make sure that all the connections necessary to operate the equipment have been properly prepared.
2.2 Positioning
The hot air generator
easyTERM
must be installed
vertically
, as shown in fig. 2.2.
Assemble the inlet and outlet ducts (with supplied screws), as shown in fig. 2.1.
Use the supplied special supports to hang or to anchor the appliance. Use an adequate
anchoring system to keep the machine in the working position.
Positioning of the
easyTERM
must be done according to the minimum recommended distances that allow a
proper machine operation and to perform maintenance when needed.
Choose, depending on the type of installation, the most suitable position within the room.
In case of long periods of unuse,
close the air inlet and the air outlet with insulating material!
fig. 2.1 - Inlet and outlet duct assembling
n.20 screws
flanged hexagonal
head 4,2x13
self-tapping
bracket
washer
grower
washer
M8 screw
bracket
washer
grower
washer
M8 screw
