Termozeta 105033, Instruction Manual

ENGLISH 

17 

iron must be used and left at rest on a firm surface. 

NO MORE WATER DURING USE 

• If there is no more water in the boiler, the jet of steam becomes less and finally 
disappears. 
• Carefully follow the instructions given below to fill up the boiler again: 

- 

press button (11) on the iron, until no more steam is being produced;

- 

press the ON/OFF switch of the boiler (2) bringing it to the “OFF” position;

- 

unplug the appliance from the outlet;

- 

slowly unscrew the boiler cap (5) being careful of any possible residual 
steam;

- 

fill up the boiler following instructions given in the “HOW TO FILL THE 
BOILER WITH WATER” paragraph;

- 

switch on the appliance again following the same instructions given in the 
“STARTING UP” paragraph.

 
WARNING! 

Always unplug the iron from the outlet before filling the boiler with water.

WHEN YOU HAVE FINISHED IRONING 

• Press the ON/OFF switch of the boiler (2) bringing it to the “OFF” position. 
• Unplug the appliance from the outlet. 
• Rest the iron on base (3) and wait for the appliance to completely cool down 
before carrying out any operations.

4 – DRY IRONING 

• Place the appliance on a firm flat surface. 
• Rest the iron on the boiler base (3). 
• Select the proper temperature by turning the control knob (13) on the iron. 
• Completely unwind the power cord (7) and plug into the outlet. 
• Put switch (2) to position “1” to turn on the appliance. 
• When the pilot light (14) goes out, the iron is ready for use. 
• The pilot light (14) on the iron will light up and go out automatically while you are 
ironing to show that the soleplate is being kept at a constant temperature. 
• When you have finished ironing to turn off the appliance. Let the iron cool down.