581-438 8’ Modern Bipod 4 Seat
STEP #2:
Remove swing hanger pendulums from the swing hanger assemblies. Using S-
hooks, attach seats to chain and chain to swing hanger pendulums. Close
the S-hooks to within .034” (1/32”) using S-hook pliers.
STEP #3:
Assemble top portion of swing hangers on top rail following spacing on
page 1 diagram.
STEP #4:
Footing holes may be marked out and dug from footing layout, however, it
is easier to position swing in proper location, mark holes, move swing
aside, and dig holes.
STEP #5:
Stand swing upright onto legs and brace in footing holes so that 2’ – 3’
of pipe will be under intended level of resilient surfacing and top rail
is at desired height.
STEP #6:
Plumb and level entire unit. Tighten set screws by using short length of
pipe on end of socket key to add leverage. Pour concrete. Crown surface.
Wait 48 hours before removing braces and using equipment.
STEP #7:
Attach assembled seats to swing hangers by reattaching the pendulums to
the swing hangers. Do not over tighten bolt on pendulum. Hangers must
move freely.
STEP #8:
Attach warning label and Manufacturer’s Identification label to a clean
surface. The labels should be attached in a location where they are
clearly visible and legible and away from normal hand and foot placement
areas. The labels must be replaced if they become illegible, destroyed or
removed. Contact your SportsPlay distributor for replacements.
