6
SNMP Configuration
A SNMP configuration page is available as shown in the picture below:
Figure 10. SNMP Configuration Menu
The SNMP configuration menu allows to input the IP address of trap receiver and to change, enable and disable the trap community strings.
Host IP used to set the IP address of the computer with running management system, which receives the SNMP TRAP.
Parameters Read Community, Write Community, Trap Community are used for the SNMP exchange authenticity.
After modifying the values press the button “Save Config” to reboot the server and update the entered parameters.
Transmitter control
When the device completes start-up, operation will begin and the Control screen will appear as in Figure 11.
Parameters of the transmitter can be selected by selecting different menu items in the control page.
Figure 11. Transmitter control page
Detailed description of control page:
•
Laser
Laser diode can be switched On or Off.
ON: laser diode switched on.
OF: laser diode switched off.
•
Load power
The transmitter has a built-in RF power meter, which monitors the total power in the RF test point. This value directly relates to the laser optical modulation
index (OMI). It depends on input signals values and number of channels and can be changed by the attenuator.
If RF output power is less than -20 dBm, web server generates error message “Low RF level”, if it is more than -5 dBm, then the message” High RF
level” is displayed.
Note
: measurement of RF output level has not instrument accuracy, it indicates the approximate output level power and output level variation.
