14
6.8. SNMP settings
Figure 24 "SNMP settings" table is located in “IP parameters” tab.
The description of the SNMP configuration parameters:
"Read Community" - community name acts as a password that is shared
by multiple SNMP agents and one or more SNMP managers. "Read
Community" password is used for read-only access to the modules
parameters.
"Write Community" - is the password used for read-write access to the
modules parameters.
"Enable TRAP" - SNMP traps are alerts generated by agents on a managed
device. Check this box to enable TRAP generation. The module generates
traps when the diagnostic message occurs.
"TRAP Community" - is the password used for accessing of TRAPS.
"Host IP #1","Host IP #2""Host IP #3" - IP addresses of hosts with SNMP
managers, where TRAPS will be send.
Figure 24. "SNMP settings" table
6.9 IP settings
All device IP settings can be configured here – IP address, subnet mask,
gateway, DNS (Domain Name System), see Figure 25 "IP settings table".
IP parameters will be updated immediately after pressing „Update“ button
and redirect to new location.
NOTE
: Press the
RESET
and default IP button for more than three seconds
to set default IP address of the control Ethernet interface (see Figure 1
"External view of the module").
Figure 25. IP settings table
6.10 E-mail-settings
The device can send e-mail reports if errors were detected. SMTP
protocol is used for that. Figure 26 “E-mail-settings table” shows
parameters related to this feature. “Enable e-mail error report”
checkbox enables error monitoring. All errors within “timeout”
period will be gathered, and send to the e-mail address, provided
in “Receiver e-mail address” input box. Comma separated e-mail
addresses can be used to send report to multiple addresses. The
timer will be started as soon, as the first error is detected, and
stopped when e-mail is sent. The timer will be restarted again if
a new error will appear.
“Sender e-mail address” can be used as authentication in the
SMTP server side.
SSL (SMTPS) protocol is not supported.
Figure 26. E-mail-settings table