16
Maintenance
Belt Replacement
PTO Belt
1.
Disconnect the PTO shaft.
2.
Remove the two shields (A) and the nut (B) from the
idler.
3.
Remove the four bolts (C) to remove the center drive
pulley assembly.
4.
Remove the four bolts (D) and the bolt on the idler
brackets (E).
5.
Remove idler.
6.
Twist the bracket (F) and remove the belt from the
pulley around the bracket. It may be necessary to
loosen the nuts (G) to allow the bearing to rotate in
the flanges.
7.
Install a new belt (B51 V-belt) onto the pulley and
reassemble the center drive-pulley assembly. Torque
the 3/8" bolts to 30 +/- ft. lbs.
8.
Reinstall center drive-pulley assemly into drive frame
and torque bolts to 30 +/- ft. lbs.
9.
Wrap the belt around the small pulley and reassemble
the idler to the proper belt tension.
10.
Reinstall the two shields.
C
C
A
B
D
E
F
G
