9
First, install your DVB-T receiver to the point where the antenna is connected. Now
connect the antenna cable of the antenna 500 to the antenna input on your DVB-T re-
ceiver. Note: You may need to align the antenna to the transmitter or in its polarity (verti
-
cal or horizontal). This depends on the reception characteristics in your reception area.
In case that your DVB-T TV card / receiver cannot provide a phantom powering (see
manual for further details), you need a power supply unit to energise the antenna.
Start a channel scan. Then start optimising the positioning of the aerial by using the
level- and quality display of the receiver (see the manufacturer manual for further
informations). Try different positions with the antenna to adjust the device for the best
possible reception.
If no or not all channels are found, please check all cable connections and make any
necessary alignment and positioning of the antenna. Then start a new channel scan.
Indoor
Outdoor
STB or Digital TV
Power Adapter
Water-Drop Loop
(recommended)
Coaxial Cable
AC Adaptor
(9-12 Volt / 250 mA)
Deutsch
English
